The 'P500 Connector' is designed to save time and money by using a plug system to connect the motor to its main cable instead of a splice. Splicing is labour intensive and is often a fail point on long runs of cable especially in hazardous areas. It is ideally suited for back up generators and pumps that are used from site to site. No need for splicing runs of cable - just plug in.

ADVANTAGES

• Eliminates the need for field splicing kits that require cure time prior to pump installation and are difficult to use, especially in poor weather conditions.
• Eliminates the cumbersome task of handing pump units with factory connected power supply cables.
• Reduces the chance of damage to power supply cable by shipping cable on a separate spool, instead of packaging cable with pump unit.
• Installation is made simple by reeling power supply cable into well tower or leg system from cable spool.
• Generic design allows adaptation to virtually all makes of power supply cable and submersible deepwell pump motors.
• Determining a ground fault location is made easy by simply un-plugging power supply cable from motor leads and checking power cable only and motor only.
• Prevents water migration inside power cables when damage to cable jacket or insulation occurs.